Technical Information; General Specifications - Jaga Helios electric Manuel D'installation Et D'utilisation

19.3. LEGAL PROTECTIVE ZONE
– An electrical radiator with insulation class II may be placed in zone A. In bathrooms and kitchens
the socket outlet (never a plug contact) has to be placed at a minimum height of 25cm above the
floor. The radiator may never be installed lower than the adapter socket outlet. A fused spare
has to be used outside the room.
– In zone B, an electric radiator of insulation class II may be connected to the electricity grid via a
plug contact that is placed in zone B.
– The appliance must be mounted and connected by an acknowledge installer in accordance with
the installation instructions and national and currently applicable local regulations.
20. TECHNICAL INFORMATION
20.1. GENERAL SPECIFICATIONS
– Operating voltage: 230V +/-10% 50Hz.
– Maximum power of 1250W, resistive load.
– Power supply cable: 800mm, 3 Conductors.
– Heating standby mode consumption: <0,5W.
– Electronic PID (Proportional Integral Derivative) control, triggered by a triac.
20.2. SURROUNDINGS
– IP44 (control panel horizontal oriented after installation).
– Operating temperature: 0°C to +50°C.
– Storage temperature: -20°C to +70°C.
– Comfort temperature setpoint: between +7°C and +30°C approximately.
– Class II, if correctly installed (according to EN60335-1).
– NTC (negative temperature coefficient) electronic temperature sensor.
20.3. MANUFACTURER
Jaga nv
90
A
B
Fig. 1: Bathroom zone classification