ZUMEX SPEED SELF-SERVICE Manuel De L'utilisateur page 15

MANUAL SpeedSelf&Cooler 26/10/07 12:24 P gina 15
• Place the machine on the base stand, Fig. 2 (drop-down diagram), matching
the inside corners of the base of the machine with the two rubber plugs of the
base stand, to match the holes of the fixing brackets with those of the machine.
Fix the machine with the screws. Fix the drip tray with its filter to the base
stand.
• Place the peel outlets, Fig. 2.
• Screw the tap, as shown in Fig. 2 (drop-down diagram) to the machine's juice
container which includes a threaded front outlet to attach the tap.
5 - Zumex Speed Cooler Podium
• When you purchase a Zumex Speed Cooler Podium machine, you will receive
two packages: Open both packages, which will include the juicer and the base
stand.
• After removing the packaging of the base stand, remove the screws of the
fixing bracket, Fig. 1 and keep it for assembly at a later stage. Prepare the
following components that will be inside the waste container, inside the base
stand (see section 5 of the manual to identify the elements):
Peel container: Remove the packaging and reserve for assembly.
Deposit, drip tray with filter, pump cover, tap piston, tap joint,
control lever and fixing plate: reserve these elements for the assembly
of the dispenser group.
Place the empty waste container inside the base stand.
• To install these elements, block the front wheels of the base stand with the
brake pedal to avoid it from moving during the installation, details in Fig. 1.
• Place the machine on the base stand, Fig. 3 (drop-down diagram), matching
the inside corners of the base of the machine with the two rubber plugs of the
base stand, placing the cables inside (power supply cable and photocell bus)
through the central opening. Fix the machine with the screws.
• After fixing the machine on the base stand, open the back cover of the base
stand by turning the knob counter-clockwise, Fig. 4. When the cover is removed,
you will see the connectors inside. Proceed to connect the juicer. Also connect
the photocell cable to its socket inside the machine. Close the back cover of
the base stand.
28
• Assemble the dispenser of the cooling group in this order:
1. Assemble the piston-joint and the lever to the deposit, following
the instructions described in the attached diagram.
2. Place the deposit
3. Adjust the cover of the pump inside the deposit with the arrow
pointing towards you.
4. Attach the metallic fixing plate to fix the deposit.
• Adjust the photocells, in accordance with the quantity of juice you wish to
store in the deposit, Fig. 5.
• Fix the drip tray to the base stand and place the lateral peel containers.
6 - Connect the machine's cable to a standard socket with a ground connection.
7 - Make sure that the cover is placed correctly; otherwise the safety detectors
of the machine will prevent it from starting.
3
1
REMEMBER:
2
Never use fruit with a diameter
that exceeds 81 mm
(recommended between 65 and
78 mm)
EN
29