Worx Landroid WG793E Mode D'emploi page 14

Open the keypad window
by pressing the large red
button on the top of your
Landroid
Press and hold down the
Power ON/OFF
until the Landroid L turns on.
®
Input the default PIN 0000
Press the key and close
the keypad window: your
Landroid L will now find its
®
way to the charging base.
Watch the Landroid
returns to the charging base
and modify the positioning
of the boundary wire if
necessary. When the
Landroid L successfully
®
returns to the charging base,
this means the installation has
been successfully completed!
Now your Landroid L will start
®
to fully charge.
14 NOTE: If your Landroid
button and close keypad window to send it back to mowing.
EN
• If your Landroid
outside its territory, it
will not move and the
Warning
display will indicate
"outside working
area" error. Just move
it inside its territory and
repeat step 2.
NOTE: Please refer to the Programming and Troubleshooting Guide for more information.
2
L.
®
key
L as it
®
L is in the charging base during a time you have programmed it to mow, then simply press the STOP
®
L is • If your Landroid
®
is inside its territory
but the display says
"outside working
area" , and the LED is on,
it means you clamped
the boundary wire ends
incorrectly. Just reverse
them.
L • Your Landroid L should
® ®
always remain switched
on. If you ever need to
turn it off, then make
sure you place it within
its boundary area before
you switching it back on
again.
• Should your Landroid L
®
stop operating
unexpectedly, just press
the STOP button, open
its keypad window, press
its ON/OFF key to ON,
press
correct the problems,
button, close its
keypad window.