Safety Instructions For Maintenance; Operation - Husqvarna RA850 Manuel D'utilisation

7. Make sure that the screws on the cutting attachment
are tightened.
8. Make sure that the blades and the cutting
attachment guard is not damaged. Replace
damaged parts.

Safety instructions for maintenance

WARNING: The cutting attachment can
continue to rotate after the throttle/power
trigger has been released. If you have a
gasoline operated product, remove the
spark plug cap from the spark plug. If you
have a battery operated product, remove the
battery from the product. Make sure that the
The working technique
WARNING: Branches or grass can get
caught between the cutting attachment
guard and the cutting attachment. Always
stop the engine/motor before you clean the
cutting attachment.
• Use full throttle/speed when you cut and decrease to
idle speed after each cut.
CAUTION: Engine/motor damage can
occur if the engine runs for too long at
full throttle without load.
Recommended use for the cutting
attachment
The cutting attachment blades moves with a small angle
and can cut in all directions. Move the cutting
attachment along the ground at a height where the
support cup touches the ground. Use the cutting
attachment to cut:
1050 - 002 - 12.04.2019
cutting attachment has stopped fully before
you do maintenance.
WARNING: The gear housing gets hot
during operation of the product. Hot surfaces
can burn you, do not touch the gear
housing.
• Always wear heavy-duty gloves when you repair the
cutting attachment. The cutting equipment is very
sharp and can easily cause cuts.
• Use only original spare parts for repairs.
SAVE THESE
INSTRUCTIONS

Operation

• Park areas and road edges.
• Road side and near fences.
7