Safety Instructions For Operation - Husqvarna ECA850 Manuel D'utilisation

• These instructions supplement the instructions
that were included with the product. For other
procedures, please refer to the operating
instructions for the product.
• Under no circumstances may the design of the
attachment be modified without the permission of
the manufacturer. Do not use an attachment that
appears to have been modified by others and
always use original accessories. Non-authorized
modifications and/or accessories can result in
serious personal injury or the death of the
operator or others.
Other safety information
• Avoid Dangerous Environment – Don't use
appliances in damp or wet locations.
• Don't Use In Rain.
• Keep Children Away – All visitors should be kept
at a distance from work area.
• Dress Properly – Do not wear loose clothing or
jewelry. They can be caught in moving parts. Use
of rubber gloves and substantial footwear is
recommended when working outdoors. Wear
protective hair covering to contain long hair.
• Use Safety Glasses – Always use face or dust
mask if operation is dusty.
• Use Right Appliance – Do not use appliance for
any job except that for which it is intended.
• Avoid Unintentional Starting – Don't carry
plugged-in appliance with finger on switch. Be
sure switch is off when plugging in.
• Don't Force Appliance – It will do the job better
and with less likelihood of a risk of injury at the
rate for which it was designed.
• Don't Overreach – Keep proper footing and
balance at all times.
• Stay Alert – Watch what you are doing. Use
common sense. Do not operate appliance when
you are tired.
• Store Idle Appliances Indoors – When not in use,
appliances should be stored indoors in dry, and
high or locked-up place – out of reach of children.
• Maintain Appliance With Care – Keep cutting
edge sharp and clean for best performance and
to reduce the risk of injury. Follow instructions for
lubricating and changing accessories. Keep
handles dry, clean, and free from oil and grease.
• Check Damaged Parts – Before further use of
the appliance, a guard or other part that is
damaged should be carefully checked to
determine that it will operate properly and
perform its intended function. Check for
alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any
other condition that may affect its operation. A
guard or other part that is damaged should be
properly repaired or replaced by an authorized
service center unless indicated elsewhere in this
manual.
4

Safety instructions for operation

WARNING: Read the safety instructions
that follow before you use the product.
• Do not let children to use the product.
• Do not let anyone else to use the product without
first made sure that they have understood the
contents of the operator's manual.
• Keep unauthorized persons at a distance.
Children, animals, onlookers and helpers should
be kept outside the safety zone of 15 m (50 ft)
while you work. Stop the product immediately if
anyone go near.
• Make sure you can move and stand safely.
Check the area around you for possible
obstacles (roots, rocks, branches, ditches, etc.)
in case you must move suddenly. Take great
care when you work on sloping ground.
• Examine the work area. Remove all loose
objects, such as stones, broken glass, nails,
steel wire, string, etc. that could be thrown out or
become wrapped around the blades or cutting
attachment guard.
• Look out for thrown objects. Always wear
approved eye protection. Do not lean over the
cutting attachment guard. Stones, rubbish, etc.
can be thrown up into the eyes causing blindness
or serious injury.
• Do not use the product in bad weather, such as
dense fog, heavy rain, strong wind, intense cold,
etc.
• Do not use the product unless you are able to
call for help in the event of an accident.
• The engine/motor must be switched off before
moving.
• Do not put the product down with the engine/
motor running unless you have it in clear view.
• Always use both hands to hold the product. Hold
the product at the side of your body.
• Use your right hand to control the throttle trigger/
power trigger.
1153 - 001 - 22.08.2019