Husqvarna RA850 Manuel D'utilisation page 6

• Use breathing protection when there is a risk of dust.
• Keep first aid equipment close at hand.
Safety devices on the attachment
WARNING: Read the warning instructions
that follow before you use the attachment.
This section contains the attachment's safety features,
its purpose and how checks and maintenance should be
carried out to ensure that it operates correctly. See
instructions under the heading
overview on page 2 to find where these parts are
located on your attachment.
The life span of the attachment can be reduced and the
risk of accidents can increase if attachment
maintenance is not carried out correctly and if service
and/or repairs are not carried out professionally. If you
need further information please contact your nearest
servicing dealer.
WARNING: Never use an attachment with
defective safety components. The
attachment's safety equipment must be
inspected and maintained as described in
this section. If your attachment fails any of
these checks, contact your service agent to
get it repaired.
WARNING: All servicing and repair work on
the product requires special training. This is
especially true of the product's safety
equipment. If your product fails any of the
checks described below you must contact
your service agent. When you buy any of
our products we guarantee the availability of
professional repairs and service. If the
retailer who sells your product is not a
6
Cutting attachment
servicing dealer, ask him for the address of
your nearest service agent.
To do a check of the cutting attachment and
the cutting attachment guard
WARNING: Do not use a cutting attachment
without an approved cutting attachment
guard. If an incorrect or defective cutting
attachment guard is installed, it can cause
injury.
1. Stop the engine and make sure that the cutting
attachment stops.
2. If you have a gasoline operated product, remove the
spark plug cap from the spark plug. If you have a
battery operated product, remove the battery from
the product.
3. Put on protective gloves.
4. Make sure that the blades are not damaged.
Replace the blades if they are damaged. Refer to
replace the blades on page 10 .
5. Examine the blades. Make sure that there is no
clearance between the blades. If there is a clearance
between the blades, the blades must be adjusted.
To adjust the clearance between the blades
Refer to
on page 11 .
6. Make sure that the support cup is not damaged.
Replace the support cup if it is damaged.
To
1050 - 002 - 12.04.2019