Yamaha DSP-E492 Mode D'emploi page 11

Connecting with a Dolby Digital (AC-3) Decoder
If you have a Dolby Digital (AC-3) Decoder unit or an LD player etc. which incorporates a Dolby Digital (AC-3) Decoder, its discrete
outputs can be connected to this unit.
6CH DISCRETE
INPUT
VIDEO SIGNAL
AUDIO SIGNAL
Notes
•
The laserdisc player (or another unit) must be also
connected to the DVD/LD (or TV/DBS) AUDIO SIGNAL
INPUT terminals of this unit for playing a source with the
Dolby Pro Logic Surround decoded or in normal stereo (or
monaural).
•
The discrete signals input to this unit cannot be recorded by
a tape deck, MD recorder or VCR. To record a source played
on the laserdisc player (or another unit), it must be
connected to the DVD/LD (or TV/DBS) AUDIO/VIDEO
SIGNAL INPUT terminals of this unit.
6CH DISCRETE OUTPUT
MAIN CENTER SURROUND
SUB
WOOFER
MAIN CENTER REAR MAIN CENTER
INPUT
from
AMP/RECEIVER
PREOUT
SUB SUB
WOOFER (SURROUND) WOOFER
MONITOR
OUT DVD/LD TV/DBS
TAPE REC
1 2 3 4
PB OUT
CD TUNER TAPE DVD/LD TV/DBS
(LINE 1) (LINE 2) ( MD )
INPUT
Dolby Digital (AC-3) Decoder unit
REAR
(SURROUND)
IN OUT
VCR
IN OUT
VCR
VIDEO OUT
AUDIO OUT
Laserdisc player with AC-3 RF output or
another unit with AC-3 RF output
•
If you made no connection to the SUBWOOFER input
terminal of this unit or you will not use a subwoofer, you
should make a setting for distributing signals at the LFE
channel to the right and left MAIN output terminals on the
Dolby Digital (AC-3) Decoder unit.
(For details, refer to the owner's manual for the Dolby Digital
(AC-3) Decoder unit.
DIGITAL
IN
DIGITAL
OUT
RF Demodulator
AC-3 RF
IN
AC-3 RF
OUT
11