AYA ATI3 Instructions D'utilisation page 68

Be aware that the glue that join the plastic or wooden material to the

furniture, has to resist to temperature not below 150℃, to avoid the
unstuck of the paneling.
The rear wall, adjacent and surrounding surfaces must therefore be

able to withstand an temperature of 90℃.
Before installing the hob, make sure that
 The work surface is square and level, and no structural members interfere with space
requirements.
 The work surface is made of a heat-resistant and insulated material.
 If the hob is installed above an oven, the oven has a built-in cooling fan.
 The installation will comply with all clearance requirements and applicable standards and
regulations.
 A suitable isolating switch providing full disconnection from the mains power supply is
incorporated in the permanent wiring, mounted and positioned to comply with the local wiring
rules and regulations.
 The isolating switch must be of an approved type and provide a 3 mm air gap contact separation
in all poles (or in all active [phase] conductors if the local wiring rules allow for this variation of the
requirements).
 The isolating switch will be easily accessible to the customer with the hob installed.
 You consult local building authorities and by-laws if in doubt regarding installation.
 You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall surfaces
surrounding the hob.
After installing the hob, make sure that
 The power supply cable is not accessible through cupboard doors or drawers.
 There is adequate flow of fresh air from outside the cabinetry to the base of the hob.
 If the hob is installed above a drawer or cupboard space, a thermal protection barrier is installed
below the base of the hob.
 The isolating switch is easily accessible by the customer.
67