Compatible Devices; Charging External Devices - SilverCrest SPBS 5000 A1 Mode D'emploi

Compatible devices

You can use the solar charger to charge end devices that require
a charging current of at least 80 mA and a maximum of 2,1 A.
If the connected end device requires a current of less than 80 mA
or more than 2,1 A, the solar charger will switch itself off immedi-
ately after being switched on with the ON/OFF button
case, check the charger's suitability for your end device on the
basis of the technical data of your end device.
NOTE
► If the device switches off automatically, it can only be
switched back on if it has been charged for a short time
beforehand with a USB mains adapter.

Charging external devices

Connect the charging cable of your end device to the USB port
on the solar charger and to your end device.
♦ If charging does not start automatically, press the ON/OFF
button briefly to start the charging process.
The LED
is being charged. Once your device is fully charged, the solar
charger switches off. To interrupt the charging process, you can
disconnect the end device. If your end device is not fully charged
and the LED
charger's battery is discharged. The solar charger's battery must
be recharged again before you can charge end devices.
Simultaneous charging of the integrated battery and a connected
end device is possible in solar operation and via the micro USB
port .
│ GB │ IE │ NI
■ 14
lights up for as long as the connected device
goes out during charging, this means the solar
. In this
SPBS 5000 A1