Charging With The Usb Cable - SilverCrest SPBS 5000 A1 Mode D'emploi

Charging with the USB cable

If there is no sunlight available, you can charge the battery of the
device with the USB cable
CAUTION
► Due to the high battery capacity and bearing in mind the
charging time, we recommend charging the power bank
using a USB mains adaptor (not supplied).
► Use only a USB mains adapter with an output voltage of
5 V and an output current of at least 2.1 A to charge the
power bank
■ To do this, connect the micro-USB plug of the charging cable
to the device's micro-USB port
■ Connect the USB plug of the USB cable
tion of a USB mains adapter.
A rough estimate of the charge level is shown during charging by
means of the charge level LEDs
Charge level LEDs
One LED is flashing
One LED is on, the second LED is flashing
Two LEDs are on, the third LED is flashing
Three LEDs are on, the fourth LED is flashing
All LEDs are on
│ GB │ IE │ NI
■ 12
.
.
.
to the USB connec-
Charge level
< 25%
25–49%
50–74%
75–99%
100%
SPBS 5000 A1