Noise/Vibration Information; Declaration Of Conformity - Bosch PSM 18 LI Notice Originale

OBJ_BUCH-1201-001.book Page 19 Monday, May 31, 2010 1:04 PM

Noise/Vibration Information

Measured sound values determined according
to EN 60745.
Typically the A-weighted sound pressure level of
the product is 72 dB(A). Uncertainty K=3 dB.
The noise level when working can exceed
80 dB(A).
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Vibration emission value a
2
K =1.5 m/s .
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
exposure.
The declared vibration emission level repre-
sents the main applications of the tool. However
if the tool is used for different applications, with
different accessories or poorly maintained, the
vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 2006/42/EC.
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Bosch Power Tools
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
14.04.2010
Assembly
2
=7 m/s , Uncertainty
h
Battery Charging (see figures A–B)
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
fore using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
The lithium ion battery is protected against
deep discharging by the "Electronic Cell Protec-
tion (ECP)". When the battery is empty, the ma-
chine is switched off by means of a protective
circuit: The inserted tool no longer rotates.
chine has been automatically switched off. The
battery can be damaged.
To remove the battery 2, press the battery un-
locking button 1 and pull the battery out of the
power tool toward the rear. Do not exert any
force.
Dr. Eckerhard Strötgen
Head of Product
Certification
Before any work on the machine (e. g. main-
tenance, changing the tool, etc.) as well as
during its transport and storage, lock the
On/Off switch in the off position. There is
danger of injury when the On/Off switch is
unintentionally actuated.
Use only the battery chargers listed on the
accessories page. Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
Do not continue to press the
WARNING
On/Off switch after the ma-
2 609 004 215 | (31.5.10)
English | 19