Remote Controller And Care; Using The Remote Controller; Switching The Mode; Batteries - Pioneer SuperTuner III DEH-P8200R Mode D'emploi

Remote Controller and Care

Using the Remote Controller

This product is equipped with a remote controller for convenient operation.
• Point the controller in the direction of the front panel to operate.
• When the controller is not in use, attach it firmly to the provided Mounting base.
Precaution:
• Do not store the remote controller in high temperatures or direct sunlight.
• The controller may not function properly in direct sunlight.
• Do not let the remote controller fall onto the floor, where it may become jammed under the brake or
accelerator pedal.

Switching the Mode

When the head unit is connected to a DSP, change the remote controller setting. While
pressing the BAND button, press the FUNCTION button on the remote controller to
change to the ADD ON DSP mode. To return to the previous mode, press the AUDIO but-
ton while pressing the BAND button on the remote controller.
Precaution:
• If you do not connect a DSP to the head unit, do not switch to the ADD ON DSP mode. If you do,
correct operation will not be possible.
• Reset the remote controller when you change batteries.

Batteries

• Remove the cover on the back of the remote controller and insert the batter-
ies with the (+) and (–) poles pointing in the proper direction.
Precaution:
• Use only AAA or IEC R03 1.5 V batteries.
• Remove the batteries if the remote controller is not used for a month or longer.
• Do not attempt to recharge the supplied batteries.
• Do not mix new and used batteries.
• If the event of battery leakage, wipe the remote controller completely clean and install new batter-
ies.
7