Subwoofer Setting Adjustment (Sub-W2); Non Fading Output (Nonfad) - Pioneer SuperTuner III DEH-P8200R Mode D'emploi

Audio Adjustment A Title (English)

Subwoofer Setting Adjustment (Sub-W2)

When the Subwoofer output is ON, you can adjust the cut-off frequency and the output
level of Subwoofer.
1. Press the AUDIO button and select the Subwoofer setting mode
(Sub-W2) in the Audio Menu.
2. Select the frequency to 50 Hz,
80 Hz or 125 Hz with the 2/3
buttons.
3. Increase or decrease the output
level with the 5/∞ buttons.
The display shows "+ 6" – "– 6".
Note:
• You can select the Subwoofer setting mode only when Subwoofer output is switched ON in the
Subwoofer ON/OFF mode.

Non Fading Output (NonFad)

When the Non Fading Output setting is ON, the audio signal does not pass through this
unit's low pass filter (for the Subwoofer), but is output through the RCA output.
Note:
• When the Subwoofer Controller setting is only "S.W Control:EXT", you can switch the Non
Fading Output ON/OFF mode. (Refer to page 49.)
1. Press the AUDIO button and select the Non Fading Output ON/OFF
mode (NonFad) in the Audio Menu.
2. Switch the Non Fading output
ON/OFF with the 5/∞ buttons.
41