Panasonic TY-RM09SL Mode D'emploi page 4

How to Use
Copy the Set Up Loader data to the other units
Set the unit data receiving mode
1
2
1 second
Copy the Set Up Loader data to the unit
1
2 Data copy has been successfully completed when the progress display
reads 100%, and you can stop aiming the Set Up Loader at the unit.
Then wait while the data is being written into the unit's memory, until
"PLEASE TURN OFF" is displayed.
Finish the data copying
1 Turn the unit off when "PLEASE TURN OFF" is displayed.
2 Turn the unit on and you can enjoy watching the unit with the
same setting as the master set.
Note:
On-screen display differs by the unit or installed terminal
board.
4
Press the [POWER] key on the Set Up Loader to turn the unit on.
Press [A] then [B] in order within 1 second to set the
data receiving mode.
When you enter the DOWN LOADING mode, "DOWN
LOADING" will be displayed. If not, repeat this
procedure 2 again.
Operate the Set Up Loader less than 1 m from the
unit.
Press the [ENTER] key and start copy. Point the Set
Up Loader at the unit's remote control sensor
until the progress becomes 100%. If an error
occurs while copying data from the Set Up Loader,
move closer to the unit and repeat Procedure 1 from
the beginning.
If on-screen display comes up with the error or the
[RED] LED (upper left of the Set Up Loader) blinks,
turn the unit off and repeat the procedure 1 in <Set
the unit data receiving mode> again. If error appears
again none the less, make sure that the master set
setting copy is successfully operated.
[DOWN LOADING]
Less than 1 m
100%
PLEASE TURN OFF