Installation Instructions - USRobotics 5465 Guide D'installation Rapide

Installation Instructions

Step One: Connect Your Router
1. Connect your DSL or Cable modem to the router:
A. Power off your computer and your DSL or Cable modem.
B. Connect the provided antenna to the back of the router.
C. Do one of the following:
If your modem connects to your computer with an Ethernet cable:
Locate the Ethernet cable that connects your DSL or Cable modem to
your computer's Ethernet adapter, and disconnect it from your computer
only: do not disconnect the cable from your DSL or Cable modem.
If your modem connects to your computer with a USB cable: Dis-
connect the USB cable from both the modem and your computer. You
will need another Ethernet cable in addition to the one provided with the
Wireless MAXg Router. Connect one end of the Ethernet cable to the
Ethernet port on the back of your DSL or Cable modem.
N o t e : The USB port on the router is for connecting a USB printer only.
Do not connect your modem to the USB port on the router. For
instructions on connecting a USB printer to your router, see
"Install a USB Printer" on page 7.
D. Connect the free end of the Ethernet cable to the WAN port on the rear
of the router.
English
3