Installation Instructions; Built-In Cabinet Instructions - Avintage AV7XK Notice D'utilisation

INSTALLATION INSTRUCTIONS

Before Using Your Wine Cooler
• Remove all exterior and interior packing.
• Before connecting the Wine Cooler to the power source, let it stand upright for approximately 24 hours.
• This will reduce the possibility of a malfunction in the cooling system caused by handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• The door on this appliance can be opened from either the left or the right side. The unit is delivered with the door opening
on the left side (the maximum angle of opening of the door is 100°"). Should you wish to open the door from the right,
follow the instructions 'Reversing the door swing of your appliance'.
INSTALLATION OF YOUR WINE COOLER
• The appliance should be positioned in a well-ventilated, dry room.
• Place your Wine Cooler on a position that is strong enough to support it when it is fully loaded. To level your Wine Cooler,
adjust the front leveling leg at the bottom of the Wine Cooler.
• This appliance must be fixed at the top and the bottom using the rail provided for the purpose in order to avoid any risk of
tipping when the shelves are slid out
• Locate the Wine Cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may
affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may
also cause the unit not to perform properly.
• Plug the Wine Cooler into an exclusive, easily accessible plug socket. Any questions concerning power and/or earthing
should be directed towards a qualified electrician or an authorized products service centre.
• To prevent the appliance from heating up, ensure that an adequate ventilation gap is retained and install a suitable
thermal insulation panel. An adequate flow of air to and from the cooling system must be ensured.
• The appliance must be installed to all electrical, plumbing, water and drain connections in accordance with state and local
codes.
•
The required room temperature to allow proper operation of the device must be between 5°C or 16 ° and 32 or 38
NOTE: make sure that the socket and ON/OFF switch are easily accessible after the appliance has been
installed.

BUILT-IN CABINET INSTRUCTIONS

The wine cooler door seals the installed unit almost completely, so an air vent must provided in the base of the housing.
Warmed air must flow from the front of the device to the back
measure at least 200 square centimeters in cross-section.
WARNING: to ensure the proper functioning of the appliance, air vents should never be blocked or covered.
and then expelled upwards. The ventilation channels should
°C.
28