Your Vacuum Cleaner; Before Using The Appliance For The First Time; Using The Hand-Held Vacuum Cleaner - Bosch Ready'y Lithium BBHL2 Série Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
en
Congratulations on your purchase of a Bosch vacuum
cleaner from the Readyy`y Lithium series.
This instruction manual describes various Readyy`y
Lithium models, which means that some of the equip-
ment features and functions described may not apply
to your model. You should only use original Bosch ac-
cessories, which have been specially developed for
your vacuum cleaner, to achieve the best possible va-
cuuming results.

Your vacuum cleaner

1 Floor nozzle with electric brush
2 Brush roller release button
3 Dirt container
4 Motor protection filter
5 Foam filter
6 Motor unit
7 Floor tool release button
8 Crevice nozzle*
9 Hand-held vacuum cleaner handle
10 Hand-held vacuum cleaner sliding switch
11 Hand-held cordless vacuum cleaner release button
12 Hand-held cordless vacuum cleaner handle
13 Hand-held cordless vacuum sliding switch
14 Battery charging status indicator
15 Dirt container release button
16 Charging cable
17 Brush roller
Before using the appliance for the first
time
1
Fig.
Carefully place the handle onto the main housing
and screw it into place.
2
Fig.
Plug the hand-held vacuum cleaner into the floor
nozzle and lock it into place.
To release the floor nozzle, press the release button
and pull the hand-held vacuum cleaner out of the
nozzle.
Charging
!
Caution:
Before using the vacuum cleaner for the first time,
fully charge the batteries.
To charge the appliance, only use the charging cable
included with the appliance. The charging cable
must only be connected and operated as specified
on the rating plate. Do not charge the appliance at
temperatures below 0 °C or above 40 °C.
3
Fig.
To charge the vacuum cleaner, place it near to a so-
cket. The appliance can be left standing anywhere in
6
the room.
Fig.
Plug the charging cable into the connection at the
rear of the appliance.
Plug the charging cable plug into the socket.
The charging indicator is lit up red when the appli-
ance is charging.
Once the battery is fully charged, the charging indi-
cator lights up blue and goes out after a few minu-
tes. Disconnect the appliance from the mains briefly
to check. The indicator will then light up blue again.
It is normal for the power adapter and vacuum clea-
ner to heat up and this is not a cause for concern.
Battery charging status indicator
The indicator shows the charging status of the battery.
„ Once the battery is fully charged, the indicator lights
up in blue.
„ When the indicator flashes, the battery must be re-
charged.

Using the hand-held vacuum cleaner

Vacuuming
4
Fig.
Actuate the sliding switch in the direction of the ar-
row.
Controlling the suction level
5
Fig.
Slide the sliding switch into the required position in
order to set the suction power:
Position 1
Suction with the electric brush switched on.
For simple cleaning tasks on hard floors and particu-
larly low operating noise.
The appliance achieves the maximum run time at
this level.
Position 2
Vacuuming at full power and with the electric brush
switched on.
For particularly demanding cleaning tasks. The ap-
pliance achieves a shorter run time at this level.
* Depending on model
1
2
51

Publicité

Table des Matières
loading

Table des Matières