Eliminating Minor Faults Yourself - Bosch 800 Série Notice D'utilisation

en-us

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following information.
Customer service will charge you for advice –even if the appliance is still under guarantee!
Fault
Temperature differs greatly
from the set value.
Displays do not illuminate.
Temperature display indi-
cates "E..".
Warning signal sounds,
alarm button 5 lights up.
The freezer compartment is
too warm!
Frozen food is at risk!
Freezer compartment tem-
perature display 4 flashes.
Warning signal sounds
The alarm button 5 is lit.
The freezer compartment is
too warm!
Frozen food is at risk!
Temperature display for
the freezer section 4
flashes.
Appliance is not cooling,
temperature display and
light are lit.
18
Possible cause
Power failure;
the fuse has been switched off;
the power cord plug has not been
inserted properly.
Electronics have detected a fault.
Appliance is open.
Ventilation openings have been cov-
ered.
Large quantities of fresh food are
being frozen.
Appliance is open.
Ventilation openings have been cov-
ered.
Large quantities of fresh food are
being frozen.
A fault caused the freezer section
to become too warm in the past.
Showroom mode is switched on.
Remedial action
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high wait a few hours
and check whether the temperature has
approached the set value.
If the temperature is too low check
the temperature again the next day.
Connect power cord plug. Check whether
the power is on, check the fuses.
Call customer service.
To switch off the warning signal, press the alarm
button 5.
Close the appliance.
Ensure that there is adequate ventilation.
Freeze less fresh food.
When the fault has been eliminated, the alarm
button 5goes out shortly afterwards.
To switch off the warning signal, press the alarm
button 5.
Close the appliance.
Ensure that there is adequate ventilation.
Freeze less fresh food.
When the fault has been eliminated, the alarm
display goes out shortly afterwards.
When the alarm button 5 is pressed, the tem-
perature display 4 stops flashing.
The temperature display indicates for five sec-
onds the warmest temperature which was
reached in the freezer section.
Start appliance self-test (see chapter "Appliance
self-test").
When the program has ended, the appliance
switches over to normal operation.