Information Concerning Disposal; Disposal Of Packaging; Disposal Of Your Old Appliance; Scope Of Supply - Bosch 800 Série Notice D'utilisation

Information concerning
disposal

* Disposal of packaging

The packaging protects your appliance from damage
during transit. All utilized materials are environmentally
safe and recyclable. Please help us by disposing of the
packaging in an environmentally friendly manner.
Please ask your dealer or inquire at your local authority
about current means of disposal.

* Disposal of your old appliance

Old appliances are not worthless rubbish! Valuable raw
materials can be reclaimed by recycling old appliances.
,
WARNING:
Old appliances
1. Pull out the power cord plug.
2. Cut off the power cord and discard with
the power cord plug.
3. Do not take out the trays and drawers:
children are therefore prevented from climbing
in!
4. To prevent children from becoming locked in
the old appliance:
Remove appliance doors!
5. Do not allow children to play with the
appliance once it has spent its useful life. Risk
of suffocation!
Refrigerators contain refrigerant and gases in
the insulation. Refrigerant and gases must be disposed
of professionally. Ensure that tubing of the refrigerant
circuit is not damaged prior to proper disposal.

Scope of supply

After unpacking all parts, check for any damage during

transport.

,
CAUTION:
Do not set up the appliance if it is damaged.
If there are any problems, please contact the dealer
from whom you purchased the appliance, or our after-
sales service.
The delivery consists of the following parts:
Built-in appliance
■
Interior fittings (depending on model)
■
Bag containing installation materials
■
Operating instructions
■
Installation instructions
■
Customer service booklet
■
Warranty enclosure
■
Information on the energy consumption and noises
■

Installing the appliance

Have a technician install and connect the appliance
according to the enclosed installation instructions.
,
WARNING:
Do not install this appliance:
outdoors,
■
in an environment with dripping water,
■
in rooms where there is a risk of freezing.
■
Transport
The appliance is heavy. It must be secured during
transport and installation.
,
WARNING:
Due to the appliance's weight and dimensions
and to minimize the risk of injuries or damage to
the appliance, at least two people are needed for
safe installation of the appliance.

Installation location

A dry, well ventilated room is suitable as an installation
location. The installation location should not be
exposed to direct sunlight and not placed near a heat
source, e.g. a stove, radiator, etc. If installation next
to a heat source is unavoidable, use a suitable
insulating plate or observe the following minimum
distances from the heat source:
To electric or gas stoves 1
■
To an oil or coal-fired stoves 11
■
The floor of the installation location must not give way;
if required, reinforce floor.

Ventilation

The air on the rear panel of the appliance heats up.
Dissipation of the heated air must not be obstructed.
Otherwise, the refrigeration unit must work harder. This
increases power consumption. Therefore: Never cover
or block ventilation openings!

Cavity depth

A cavity depth of 22 / " (560 mm) is recommended for
3
64
the appliance. If the cavity depth is smaller – at least
21 / " (550 mm) – the energy consumption increases
21
32
slightly.

Side by side installation

It is only possible to install appliances side by side with
a gap of at least 5.9" (15 cm).
en-us
/ " (3 cm).
1
4
/ " (30 cm).
13
16
5