Tips for saving energy
Install the appliance in a dry, well
■
ventilated room! The appliance should
not be installed in direct sunlight or
near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
Allow warm food and drinks to cool
■
down before placing in the appliance.
Thaw frozen food in the refrigerator
■
compartment and use the low
temperature of the frozen food to cool
refrigerated food.
Open the appliance as briefly as
■
possible.
The arrangement of the fittings does
■
not affect the energy rating of the
appliance.
Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
The light does not work.
Possible cause
The bulb is defective.
Light switch is jammed.
Operating noises
Quite normal noises
Droning
Motors are running (e.g. refrigerating
units, fan).
Bubbling, humming or gurgling noises
Refrigerant is flowing through the tubing.
Clicking
Motor, switches or solenoid valves are
switching on/off.
Preventing noises
The appliance is not level
Please align the appliance with a spirit
level. Use the height-adjustable feet or
place packing underneath them.
The appliance is not free-standing
Remedial action
Replace bulb. Fig. ,/B
1. Switch the appliance off.
2. Pull out mains plug or switch off fuse.
3. Slide cover forwards and remove.
4. Change the bulb.
(Replacement bulb: 220–240 V a.c., E14
bulb holder, see defective bulb for
wattage.)
Check whether the light switch can move.
Fig. ,/A
en
23