Error Message/Troubleshooting - Beurer medical BM 90 Mode D'emploi

Table for the classification of blood pressure values (measurement unit, mmhg) for adults:
Display Category
Normal range
Grade 1: mild hypertension
Grade 2: moderate hyper-
tension
Grade 3: severe hyperten-
sion
8. saving, displaying and deleting measurements on the device
saving measurements
The results of every successful measurement are automatically stored together with the date and time. If there
•
are more than 60 measurements, the oldest measurements are lost.
Displaying measurements
When switched off, press the
•
This is denoted by
If you press the memory button, MeM
•
the value measured most recently. The individual values are denoted by the memory space numbers 1 to 60.
The date of each measurement is displayed after approx. 4 seconds and after about a further 4 seconds the
time is also displayed.
By pressing the
ton, the oldest are displayed.
Turn off the device using the sTART/sTOP button or it will turn off automatically after approx. 1 minute.
•
Deleting measured values from the device
To clear the memory, press the
•
flashes on the display; confirm using the seT
•
shown on the display and the device turns off automatically.

9. error message/troubleshooting

If the blood pressure measurement has not been performed properly, appears on the display.
Error messages may appear if:
• : the cuff is fastened too loosely,
• : the cuff is fastened too tightly,
• : the pump pressure is too high,
• : you move or speak during the measurement,
• : there is a system or unit error.
systole
< 140
140 - 159
160 - 179
> = 180
MeM button. Firstly, the average value of all values stored will be displayed.
in the display.
again, further individual measurements are displayed – beginning with
MeM button, the most recent measurements are displayed; by pressing the seT
MeM button for approx. 3 seconds when switched off.
Diastole Action
< 90 Self-monitoring
90 - 99 regular monitoring by doctor
100 - 109 seek medical attention
> = 110 seek medical attention
button. When the values have been deleted,
22
but-
is