Measuring Blood Pressure - Beurer medical BM 90 Mode D'emploi

When switched off, press the seT
•
the year with the MeM button and confirm with the seT
Then set the month, day, time format (24h/12h), hour, minutes and measurement unit (mmHg/kPa) and confirm
•
each setting with the seT
After you have performed all the settings,
•
off.
Operating the blood pressure monitor with a mains part
You can also operate this blood pressure monitor with a mains part. When doing so, there must not be any bat-
teries in the battery compartment. The mains part can be obtained from specialist retailers or from the service
address using order number 071.50.
To prevent possible damage to the device, the blood pressure monitor must only be used with the mains part
•
described here.
Insert the mains part into the connection provided for this purpose on the right-hand side of the blood pressure
•
monitor.
The mains part must only be connected to the mains voltage that is specified on the type plate.
Then insert the mains plug of the mains part into the mains socket.
•
After using the blood pressure monitor, unplug the mains part from the mains socket first and then disconnect
•
it from the blood pressure monitor. As soon as you unplug the mains part, the blood pressure monitor loses the
date and time setting but the saved measurements are retained.

6. Measuring blood pressure

Ensure the device is at room temperature before measuring.
Attach the cuff
The unit may only be operated with the original cuff. The cuff is for an arm circumference of 22 to 42 cm.
Adopt the correct posture
Before every measurement, relax for about five minutes. Otherwise deviations can occur.
•
You can perform the measurement while sitting or lying. Make sure that the the cuff is at heart level.
•
button for approx. three seconds. The year display will start to flash. Set
button.
appears on the display and the device automatically switches
button.
20