Adjusting The Awning - Dometic DA20E Notice D'utilisation

Adjusting the awning

7 Adjusting the awning
7.1 Resetting the outer limit
The optimum outer limit of the awning is set by default. Over time, the setting
for the outer limit can become incorrect. The awning then fails to extend fully
or far enough so that the fabric hangs down.
Reset the outer limit as follows:
➤ Briefly press the
✓ The awning extends all the way.
➤ Press the
✓ The awning briefly moves twice, indicating the setup mode.
➤ Press and hold the
correct outer limit.
The fabric edges of the awning should not hang down and must be taut
at all ends. On long awnings the fabric may sag in the middle.
➤ Press the
✓ The awning briefly moves twice, which confirms the new setting.
I
NOTE
If the awning does not briefly move twice, you need to reset the
motor and the remote control, see chapter "Resetting the motor and
remote control" on page 47.
44
button.
and buttons simultaneously for about 6 seconds.
or button until the awning moves to the
button for about 3 seconds.
DA20E
EN