Installing The Heki2 De Luxe - Dometic Heki 2 de Luxe Instructions De Montage Et De Service

Heki2 de Luxe
7

Installing the Heki2 de Luxe

!
WARNING! Beware of injury
Disconnect the vehicle power supply before you begin and make sure it
cannot be restarted.
A
NOTICE!
Make sure that you do not damage any cables during installation.
See fig. 4
If you would like to connect the lighting:
➤ Lay the power supply line (1) in the middle on one of the two long sides.
The connection is designed for an insulated flat plug which is 4.8 mm wide and
0.8 mm thick.
The scope of delivery includes a mounting set, which is suitable for a roof thickness
of 25 – 32 mm. For roof thicknesses of 33 – 60 mm, you need to have a suitable
mounting set (see table).
➤ Measure your roof thickness W.
➤ Choose a suitable mounting set:
Roof thickness
25 – 32 mm
33 – 39 mm
39 – 46 mm
46 – 53 mm
53 – 60 mm
See fig. 5
➤ Check that the roof light has sufficient space around it (approx. 1 to 2 mm) in the
roof opening.
See fig. 6
➤ Clean the roof opening in the mounting area.
EN
Mounting bracket
colour
Grey
Black
Yellow
Blue
Red
Installing the Heki2 de Luxe
Screws
∅ 4 x 25 mm
∅ 4 x 32 mm
∅ 4 x 40 mm
∅ 4 x 46 mm
∅ 4 x 52 mm
Item no.
Included in the
scope of delivery
9104100245
9104100246
9104100247
9104100248
7