Operation; Headphone Use; Defects; Cleaning - Sonoro SO-320 Mode D'emploi

 Do not cover the ventilation openings on the rear
and underside of the device by covering the
ventilation openings with items, such as
newspapers, table-cloths, curtains, etc.
 The device is suitable for use in tropical and/or
moderate climates.
 Protect the remote control from the weather,
humidity and high temperatures (e.g. from direct
sunlight).
 Protect the device against dripping water and
splashes. Never place a container of liquid next to
or on the device.
 Protect the device against mechanical shocks and
place it on a firm surface.
 Protect the remote control from the weather,
humidity and high temperatures (e.g. from direct
sunlight).
 Protect the device against dripping water and
splashes. Never place a container of liquid next to
or on the device.
2.9

Operation

Fig. 2: Subwoofer
 Do not touch or push the subwoofer on the
bottom of the device (Fig. 2). This can destroy the
loudspeaker.
 Do not insert any object other than the permitted
CDs into the CD slot of the device. Special formats
can result in damage to your device.
 Do not use any media other than those specified in
this manual.
 The rubber feet of the device may produce stains
on certain surfaces. Please choose a suitable sur-
face on which you will place the device.
2.10

Headphone use

 Always decrease the volume of the device before
putting on the headphones. Increase the volume to
the desired level only after the headphones are in
the correct position.
 Do not adjust the volume too high when listening
on headphones. If you hear permanent noise or
background noise in your ears (ringing), immedi-
ately decrease the volume or stop using the head-
phones altogether.
 Even if your headphones are designed in such a
way that you can hear outside noises, remember
to never adjust the volume so high that you are no
longer aware of your immediate surroundings.
2.11

Defects

If the device should be defective, never try to carry
out repairs your-self.
 If the mains plug, the adapter or the mains cable of
the device is damaged, it must be replaced by the
manufacturer or the customer service department
to prevent the risk of electric shock.
 If liquids have entered the device or it has been
damaged in any other way, it must be inspected by
an authorised specialist. Disconnect the device
from the AC adapter and contact an authorised
specialist.
2.12

Cleaning

 Only clean the outside of the device with a dry,
soft cloth. Never use aggressive cleaning agents or
solvents to clean the device, as these corrode its
surface.
 If the device is badly soiled, wipe it with a slightly
moistened cloth and dry it immediately with a dry,
soft cloth.
85