Usb Playback - Sonoro SO-320 Mode D'emploi

1. Switch on the sonoroSTEREO 2.
2. Plug the RCA cable into the AUX 1 port or the
3.5mm jack plug into the AUX 2 port on the rear
of the device.
3. Press the [MENU] button until the display shows
[AUX.1 Input] or [AUX.2 Input]. You can also
press the [AUX] button on the remote control.
 The display will show the [AUX.1 Input] or
[AUX.2 Input] (Fig. 49).
4. Switch on the external device and start playback
on the external device.
15

USB playback

You can connect additional devices and play music
using the USB Charger & Playback port on the rear of
the sonoroSTEREO 2.
i
The MP3 and WMA formats can be played back.
Fig. 50: Setting USB playback
1. Switch on the sonoroSTEREO 2.
2.
Press the [MENU] button until the display shows
[USB Device] or press the [USB]-button on the
remote control.
 The display shows [USB Device] (Fig. 50).
3. Connect an external USB device to the
sonoroSTEREO 2.
 The display shows [Searching].
4. Press the [Play/Pause] button to start playback.
i
You can display the ID3 metadata, if avail‐
able, by pressing the [USB] button on the
remote control. The sequence is:
'Track  Artist  Album  Elapsed time'
106
Pause/Stop USB playback
5.
Press the click wheel or the [Stop] button on the
front of the device to pause or stop USB play-
back.
Selecting MP3 folders
6. Press the [Preset 1] button to select the previous
MP3 folder.
7. Press the [Preset 2] button to select the next
MP3 folder.