Cleaning - Sonoro SO-320 Mode D'emploi

Malfunction
Alarm does not work
Alarm light does not work.
19

Cleaning

L NOTICE!
Material damage from improper cleaning!
Only clean the device from the outside using a
dry, soft cloth. Never use abrasive or solvent-
based cleaning agents as these may damage the
surface of the device.
Possible cause
Interference caused by other radio
transmitters or devices
Alarm is not switched on
Alarm volume is set to minimum
Headphones are connected
sonoroLIGHT is not connected.
sonoroLIGHT is connected but the
dimmer function is switched off.
The lamp connected to sonoro-
LIGHT is switched off.
Elimination
Increase the distance between the
source of interference and the
sonoroSTEREO 2. Connect the
device to a different socket, so that
the source of the interference and
the sonoroSTEREO 2 are connected
to different branch circuits.
Switch the alarm on (see
Chapter 9.6 'Switching the alarm
function on/off' on page 100).
Increase the volume (see
Chapter 9.3 'Setting the alarm
volume' on page 99).
Remove the headphones from the
socket.
Connect sonoroLIGHT and set the
alarm light (see  Chapter 9.5
'Programming the alarm light
(sunrise)' on page 99 ).
Switch on the dimmer function on
sonoroLIGHT.
Switch the connected lamp on.


111