To Charge The Battery - Husqvarna LB 146P Manuel D'utilisation

4. Put a container below the product to collect the
engine oil in.
5. Tilt the product to drain the engine oil from the oil
tank.
6. Fill with new engine oil of the type recommended in
Technical data on page 13 .
7. Do a check of the oil level. Refer to
the oil level on page 11 .
Battery (LB 246PI)
WARNING: A defective battery decreases
the safety of the product. Always use a
battery approved by the manufacturer.
The battery gives power to the electrical start and is a
safety device that prevents accidental start. Remove the
battery when you do not operate the product and when
you let it stay out of view.
To start the battery
You need to start the battery before the first time you
use it.
1. Put the battery into the charger, see
battery on page 12 .
2. Wait until a minimum of 1 green lamp comes on,
approximately 10 seconds.
3. Attach the battery to the engine, see
(LB 246PI) on page 10 .

To charge the battery

If only 1 or 0 lamp indicators on the battery are on, it is
necessary to charge it. An empty battery is fully charged
in 1 hour. To charge for shorter periods of time does not
do damage to the battery.
1. Put the battery in the battery charger. (Fig. 36)
2. Connect the battery charger to a power socket,
220V, 50Hz.
Status for battery charge
LED display on the battery
LED 1 flashes
LED 1 is lit, LED 2 flashes
LED 1, LED 2 are lit, LED 3 flashes
LED 1, LED 2, LED 3 are lit, LED 4
flashes
LED 1, LED 2, LED 3, LED 4 are lit
Lamp indicator on the bat-
tery charger
Constant red light
12
To do a check of
To charge the
Electrical start
Status
0%-25%
25%-50%
50%-75%
75%-100%
Fully charged
Status
The battery charges
Lamp indicator on the bat-
tery charger
Flashing red light
Constant green light
Flashing red and green
light
To clean the air filter
1. Remove the air filter cover and remove the filter.
2. Hit the filter against a flat surface to make the
particles fall off.
CAUTION: Do not use solvent or
compressed air to clean the air filter.
3. Put the air filter back. Make sure that the air filter
fully seals against the air filter holder.
4. Put the air filter cover back.
Note: An air filter that is used for a long time cannot be
fully cleaned. Replace the air filter at regular intervals.
Always replace a damaged air filter.
To examine the spark plug
CAUTION: Always use the recommended
spark plug type. Incorrect spark plug type
can cause damage to the product.
• Examine the spark plug if the engine is low on
power, is not easy to start or does not operate
correctly at idle speed.
• To decrease the risk of unwanted material on the
spark plug electrodes, obey these instructions:
a) Make sure that the idle speed is correctly
adjusted.
b) Make sure that the fuel mixture is correct.
c) Make sure that the air filter is clean.
• If the spark plug is dirty, clean it and make sure that
the electrode gap is correct, refer to
on page 13 . (Fig. 37)
• Replace the spark plug if it is necessary.
To examine the fuel system
• Examine the fuel tank cap and the seal for the fuel
tank cap to make sure that there are no damages.
• Examine the fuel hose to make sure that there are
no leaks. If the fuel hose is damaged, let a service
agent replace it.
Status
The battery is too warm
and will start to charge
when the temperature is
correct
The battery is fully charg-
ed
The battery is damaged
and must be replaced
Technical data
287 - 006 -