Taking The Wallbox Emh2 Out Of Operation - ABL Wallbox eMH2 Mode D'emploi

28
| Wallbox eMH2 – Taking the Wallbox eMH2 out of operation

Taking the Wallbox eMH2 out of operation

In case of severe malfunctions or damage to the device, you must take the Wallbox eMH2 out of opera-
tion. To do so, proceed as follows:
1
Open the housing cover of the wallbox with
the housing cover key and put it aside.
2
Open the access flap of the internal electronic
components cover.
3
Flip the pivot lever of the internal RCCB to the
0 position.
y Also flip the pivot lever of the internal MCB
to position0.
4
Close the access flap, hook the housing cover
onto the upper edge of the housing base and
lock it using the housing cover key.
5
Open your domestic power distribution box,
disconnect the power supply cable from the
electricity grid via the MCB and close the
distribution box.
The Wallbox eMH2 is no longer connected to the electricity grid and can be removed by a qualified spe-
cialist electrical contractor if required.