Resolving Errors - ABL Wallbox eMH2 Mode D'emploi

NOTE
Interruption or completion of the charging procedure
The charging procedure may be paused by the vehicle. Otherwise, the charging procedure is automat-
ically terminated by the vehicle upon completion. These two possibilities can only be distinguished by
checking the displays inside the vehicle.
8
Unplug the charging connector from the elec-
tric vehicle's charging inlet and close it.
9
Store the charging cable ready for the next
charging procedure.
y Wallbox with charging cable
Replace the charging connector in its
storage compartment.
y Wallbox with charging socket
Unplug the charging connector from the
charging socket and store the charging
cable: the charging socket flap closes
automatically.
10 The wallbox is ready for operation and awaits
the next charging procedure:
y When the wallbox is ready for operation,
the green LED pulsates.
NOTE
Removing the charging cable from a wallbox with charging socket
If the wallbox has a charging socket, the charging cable should be unplugged from the charging socket
after every charging procedure. Otherwise, communication between the wallbox and the vehicle may
be disrupted during subsequent charging procedures.

Resolving errors

Errors may occur during the operation of the wallbox.
Description
The electric vehicle is not recognised.
Cause and suggested solution
ƒ The charging cable is not properly plugged in.
y Remove the charging connector from the vehicle's charging inlet and plug it back in.
Wallbox eMH2 – Resolving errors | 25