Using On Slopes - Stiga MPST 84 Li 48 V1 Manuel D'utilisation

Status
Operator seated.
Drive pedal in neutral position
(released pedal).
Emergency button deactivated.
Machine turned on or in motion.
Operator seated.
Drive pedal in forward or
reverse position.
Emergency push-button activated.
Cutting means engaged.
Cutting means engaged.
Machine turned on and in motion.
Machine turned on and in motion.
DANGER
If any of the results fail to match the indications
provided in the tables, do not use the
machine. Contact an Authorised Dealer to
have it checked and repaired if necessary.
NOTE
Always bear in mind that the safety devices
prevent the electric motor from starting if safety
requirements have not been met. In these cases,
once the start consent has been reinstated,
Action
Rotate the key in the drive position.
The operator gets up from the seat.
Try to
start the machine
Try turning on the machine.
The reverse gear is engaged without
holding down the consent push-
button for cutting in reverse gear.
The grass catcher is lifted or the
rear discharge guard is removed
(only for rear collection models).
The drive pedal is released.
Test drive.
the key (Fig. 11.A) must be returned to the stop
position before the machine may be restarted.

7.3 USING ON SLOPES

Comply with the limits indicated in the
"Technical Data" Tables ad in "fig. 17"
regardless of the mowing direction.
Remember there is no such thing as a "safe"
slope. Driving on grass slopes requires
particular care. To prevent overturning
or loss of control over the machine:
EN - 16
Result
The machine is ready to start.
All services are deactivated
[Push-button panel Type I]
The icon fig. 12.E flashes.
[Push-button panel Type II]
The icon fig. 12.E flashes and
the icon fig. 12.P. lights up.
The machine is turned on.
[Push-button panel Type I]
The icon fig. 12.E flashes.
[Push-button panel Type II]
The icon fig. 12.E flashes and
the icon fig. 12.O. lights up.
The machine is turned on, but
the drive pedal and the push-
button to engage the cutting
means are not functioning.
The cutting means disengage.
The cutting means disengage.
The machine slows down and stops.
No abnormal vibration or unusual
sound, the steering, the controls and
the pedals are operating normally.