Assembly; Assembly Components; Steering Wheel Assembly - Stiga MPST 84 Li 48 V1 Manuel D'utilisation

and hurled away from the machine.
(for rear collection models only).
G. Driver seat: this is where the machine
operator sits. It has a sensor connected
to safety devices for detecting the
presence of the operator.
H. Blade motor: supplies the drive
power to the cutting means.
Transmission motor: provides
I.
movement to the wheels.
J. Battery: supplies power to the motors and
all the electrical components of the machine.
K. Front bumper: this protects the
front section of the machine.
L. Steering wheel: turns the front wheels.
M. Push-button panel: an interface
which groups together the main
operating controls of the machine.

5. ASSEMBLY

CAUTION
The safety regulations to follow are described in
chap. 2. Strictly comply with these instructions
to avoid serious risks or hazards. Do not use the
machine until all the indications provided in the
"ASSEMBLY" section have been carried out.
For storage and transport purposes,
some components of the machine are
not installed in the factory and have to
be assembled after unpacking.
Unpacking and completing the assembly should
be done on a flat and stable surface, with enough
space for moving the machine and its packaging,
always making use of suitable equipment

5.1 ASSEMBLY COMPONENTS

The packaging holds the components needed
for assembly as listed in the table below:
Description
1 Steering wheel
2 Dashboard cover and steering
wheel assembly parts
3 Driver seat
4 Battery charger
5 Front bumpers
6 Anti-chipping wheels
7
Grass catcher with relative assembly
screws and instructions (
with rear collection only)
for models
EN - 9
8 Lower part of the rear plate, the grass
catcher brackets and attachments nec-
essary for completing and assembly (for
rear collection models only)
9 Side discharge chute (for models with
side discharge only)
10 Cutting-means assembly side reinforce-
ments (for side discharge models only, if
foreseen).
11 Envelope containing:
- the instruction manuals and documents;
- driving seat assembly screws;
- side discharge chute assembly fittings
(for models with side discharge only);
- 2 starter keys.
12 Mobile phone support kit (if provided).
Instructions are provided with the kit.
5.1.1 Unpacking
1. Cautiously open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.
3. Remove all the unassembled
parts from the box.
4. Remove the machine from the packaging
taking the following precautions:
• move the cutting-means assembly
to its maximum height (par. 6.6) to
prevent damage when the machine
is lowered from the base pallet;
• Lift the machine off the base pallet.
5. Move the rear drive release lever to
the unlocked position (par. 6.4).

5.2 STEERING WHEEL ASSEMBLY

1. Put the machine on a flat surface
and straighten the front wheels.
2. Mount the hub (fig. 3.A) on the shaft
(fig. 3.B), making sure that the plug (fig. 3.C)
is correctly fitted into the hub seat.
3. Fit the dashboard cover (fig. 3.D)
clicking the five fasteners into place.
4. Fit the steering wheel (fig. 3.E) onto
the hub (fig. 3.A) with the spokes
directed towards the seat.
5a. For type "l" steering wheel only
- Fit the spacer (fig. 3.F) and fasten the
steering wheel in place using the screws
supplied (fig. 3.G) in the indicated order.
5b. For type "ll" - steering wheel
only - Fasten the steering wheel in
place using the screws (fig. 3.F, 3.G)
supplied, in the indicated order.
6. Fit the steering wheel cover (fig. 3.H)
by clicking the fasteners into place.