Maintenance; Maintenance Schedule - Husqvarna 525DEPS Manuel D'utilisation

• Do not work with the shaft held straight out in
front of you as this increases the apparent weight
of the cutting attachment.
• Cut large branches in sections so that you have
better control over where they fall.
• Never cut through the swelling at the root of the
branch as this will slow down healing and
increase the risk of fungal attack.
Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.

Maintenance schedule

The following is a list of the maintenance steps that
must be performed on the product. Most of the items
are described later in this chapter.

Maintenance

Clean the external surface.
Make sure that the throttle trigger lock and the throttle works correctly.
Do a check of the stop switch to make sure that it works correctly.
Make sure that the saw chain does not rotate at idle speed.
Clean the air filter. Replace if necessary.
16
• Use the stop at the base of the cutting head to
provide support during cutting. This will help
prevent the cutting attachment from bouncing on
the branch.
• Make an initial cut on the underside of the branch
before cutting through the branch. This will
prevent tearing of the bark, which could lead to
slow healing and cause permanent damage to
the tree. The cut should not be deeper than ⅓ of
the branch thickness to prevent jamming. Keep
the chain running while you withdraw the cutting
attachment from the branch to prevent it
jamming.
Maintenance
Note:
The user must only carry out the
maintenance and service work described in this
operator's manual. More extensive work must be
carried out by an authorized service workshop.
Weekly
Daily (30 Monthly
hours)
X
X
X
X
X
1480 - 008 - 10.08.2021