Husqvarna 525DEPS Manuel D'utilisation page 13

Masquer les pouces Voir aussi pour 525DEPS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

To mix fuel
Gasoline
CAUTION:
an octane number less than 90 RON (87
AKI). This can cause damage to the
product.
CAUTION:
more than 10% ethanol concentration
(E10). This can cause damage to the
product.
CAUTION:
gasoline. This can cause damage to the
product.
Always use new unleaded gasoline with a
minimum octane number of 90 RON (87 AKI)
and with less than 10% ethanol concentration
(E10).
Use gasoline with a higher octane number if you
frequently use the product at continuously high
engine speed.
Always use a good quality unleaded gasoline/oil
mixture.
Two-stroke oil
For best results and performance use Husqvarna
two-stroke oil.
If Husqvarna two-stroke oil is not available, use a
two-stroke oil of good quality for air-cooled
engines. Speak to your servicing dealer to select
the correct oil.
CAUTION:
stroke oil for water-cooled outboard
engines, also referred to as outboard
oil. Do not use oil for four-stroke
engines.
To mix gasoline and two-stroke oil
Gasoline, liter
5
10
15
20
US gallon
1
1480 - 008 - 10.08.2021
Do not use gasoline with
Do not use gasoline with
Do not use leaded
Do not use two-
Two-stroke
oil, liter
2% (50:1)
0.10
0.20
0.30
0.40
US fl. oz.
2 ½
2 1/2
5
CAUTION:
influence the ratio of the mixture
drastically when you mix small quantities
of fuel. Measure the quantity of oil
carefully and make sure that you get the
correct mixture.
1. Fill half the quantity of gasoline in a clean
container for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION:
than 1 month at a time.
To fill the fuel tank
1. Clean the area around the fuel tank cap.
2. Shake the container and make sure that the fuel
is fully mixed. Use a fuel container with an anti-
spill valve.
3. Fill the fuel tank.
4. Tighten the fuel tank cap carefully.
5. Move the product 3 m (10 ft) or more away from
the refueling area and fuel source before starting.
CAUTION:
tanks causes malfunction. Clean the fuel
tank and chain oil tank regularly and
6 ½
12 ⅞
Small errors can
Do not mix fuel for more
Contamination in the
13

Publicité

Table des Matières
loading

Table des Matières