Fitting / Removing Brush Heads; Operation; Travelling Case - Nevadent DKZ 2 A1 Mode D'emploi

Fitting / removing brush heads

To remove the brush head 1, turn it clockwise and then pull it upwards.
To fi t the brush head 1 place it slightly off set on the hand element 2 and
then turn it anti-clockwise.
The brush head 1 must engage on being put back on. To avoid damage
to the appliance, use only original brush heads.
(For replacement brush heads, see the order card)

Operation

Warning
Due to the unaccustomed operation some gum bleeding may initially occur,
this is normal. Should this continue for more than two weeks, consult your
dentist.
• Place the brush head 1 on the hand element 2.
• Moisten the brush under fl owing water.
• Apply some toothpaste to the moistened brush.
Notice
To avoid spraying toothpaste, fi rst place the toothbrush on the teeth before
switching it on.
• Start the toothbrush with the on switch 3 and turn the sandglass 6
upside down. This indicates to you when the 2 minutes of cleaning
recommended by dentists has been completed.
• Brush the outer surfaces of your teeth fi rst of all. Place the brush head 1
on your gums and move the brush upwards/downwards from the gums
to over the crown of the tooth.
• Start again from the gums for each individual tooth.
• Clean the inner surfaces of your teeth with the same technique.
• To clean the chewing surfaces, direct the rotating brush head with light
pressure over the chewing surfaces.
• Finally, thoroughly clean the back parts of the molar teeth.
• When the sand in the sandglass 6 has passed through and all teeth
have been brushed, stop the toothbrush with the off switch 4 and fi rst
then remove it from your mouth.
• After use, clean the brush heads 1 thoroughly under running water.

Travelling case

If you wish to take the toothbrush with you on your travels, you can pack it
in the travelling case.
- 35 -