Spa Maintenance - Jacuzzi J-LXL Manuel D'installation Et Utilisation Et Entretien

Spa maintenance

Proper and regular maintenance of your spa will help it retain its
beauty and performance.
Information regarding spa cleaning and maintenance and
the products to be used can be found in the catalogue-guide
provided with the product.
I
Cleaning the filters
Your Jacuzzi ® Premium spa is equipped with a skimmer and two
high-performance filter cartridges located inside the skimmer.
Fine debris is filtered by the circulation pump drawing water
through the skimmer bag and circulation pump cartridge.
Larger impurities are filtered by the 2-speed pump drawing wa-
ter through the skimmer bag and main pump cartridge during
normal operation and at each skimming/heating cycle.
To ensure optimum performance, clean both cartridges once a
month.
Dispenser for water sanitation
At authorized Jacuzzi dealers, you can purchase a dispenser where
you can place products for water sanitation).
Dispenser for water sanitation
At authorized Jacuzzi dealers, you can purchase a dispenser where
you can place products for water sanitation).
This dispenser must be placed in the filtering cartridge (recognizable
by the grille cover on the compartment) connected to the circulation
pump.
The dispenser must always be removed (while wearing latex gloves)
along with its cover during cleaning of the filter, and is to be rein-
stalled when this operation is complete.
ALWAYS TURN POWER TO SPA BEFORE CLEANING THE FILTER
CARTRIDGES!
Refer to the filter cleaning/replacement procedure below:
A. Turn off power to spa.
(Spa Shell)
B
D
C
B. Tilt cover forward to access filter cartridges.
(The skim shield is connected by spring clips, use caution so the
lid does not snap back.)
C. Remove skimmer bag from clips, clean out, then reinstall in the
filter cover.
Replace the filter skimmer about every three months, depending
on spa use.
D Rotate each filter cartridge handle counterclockwise to un-
thread from mating wall fitting.
E
E. Lift unthreaded filter cartridge from skimmer well.
F. If used, remove the chemical feeder as instructed prior to rins-
ing the filter cartridges. Rinse debris from filter pleats on each car-
tridge using a garden hose and high pressure nozzle. Start at the
top and work downward towards handle. Repeat until all pleats
are clean.
G. Submerge both filter cartridges in spa. Tilt threaded end up-
ward to remove trapped air bubbles, then keep cartridges sub-
merged to prevent air entrapment during installation (step H).
H
H. Place each cartridge back into skimmer well, then rotated
each cartridge handle clockwise to thread back into wall fitting.
DO NOT OVERTIGHTEN!
I. Install clean skimmer bag and filter skimmer back onto the fil-
ter cover clips as shown (you can flip the filter skimmer and use
the back side to extend usage). Replace the filter skimmer about
every three months, depending on spa use.
J. Tilt filter cover back against the spa shell.Turn power to spa
back on.
31
Trapped
Air
Bubbles
F G
J
I