Sony MEX-BT4000P Mode D'emploi page 22

M:\081\XPML A7.0\ML\New Folder\4296017111_MEX-BT4000P_CaFR\01US-
MEXBT4000PU\01US02CD-U.fm
00ML+00COV-U.book Page 22 Friday, August 26, 2011 1:30 PM
Pairing
The Bluetooth device (cellular phone, audio
device, etc.) and this unit need to be
"paired" before use between each other via
the Bluetooth function.
Tips
• For details on pairing for a Bluetooth device,
refer to the operating instructions supplied with
the device.
• You can pair up to 9 Bluetooth devices with this
unit.
1
Place the Bluetooth device within 1 m
(3 ft) of this unit.
2 Press  and rotate the control
dial until "SET PAIRING" appears,
then press it.
The unit enters pairing standby mode.
3
Set the Bluetooth device to search for
this unit.
A list of detected devices appears in the
display of the device to be connected.
This unit is displayed as "Sony
Automotive" on the device to be
connected.
4
If passkey* input is required in the
display of the device to be connected,
input "0000."
22
Flashing
DR-BT30Q
Sony
Automotive
XXXXXXX
If the device supports Bluetooth version
2.1, passkey input is not required.
* Passkey may be called "passcode," "PIN
code," "PIN number" or "Password," etc.,
depending on the device.
Input passkey
"0000"
XXXX
This unit and the Bluetooth device
memorize each other's information, and
when pairing is made,
The unit is ready for connection to the
device.
Note
If " " continues to flash, the Bluetooth
device may not be compatible with this unit.
For details on compatible devices, visit the
support site on the back cover.
5
Select this unit on the Bluetooth device
to be connected.
" " or " " appears when the
connection is made.
Notes
• While connecting to a Bluetooth device, this
unit cannot be detected from another device.
To enable detection, enter the pairing mode and
search for this unit from another device.
• It may take time to search or connect.
• Depending on the device, the confirmation
display of the connection appears before
inputting the passkey.
• The time limit for inputting the passkey differs
depending on the device. If the time expires,
perform the pairing procedure from the
beginning again.
• This unit cannot be connected to a device that
supports only HSP (Head Set Profile).
masterpage:Left
stays lit.
MEX-BT4000P
4-296-017-11(1)