Operation
Location and Function of Controls
POWER/PROTECT indicator
Lights up in green during operation.
If the protection circuit activates, the POWER/
PROTECT indicator flashes. For details, see
"Troubleshooting" (page 12).
SIGNAL INPUT connector
Can be connected with the supplied RCA input
cord or high level input cord.
INPUT SELECT switch
Sets the input signal to "2CH" or "4CH."
REAR LPF (low-pass filter) switch
Sets the low-pass filter (LPF) to "ON" or "OFF."
4
GB
FRONT HPF (high-pass filter) switch
Sets the high-pass filter (HPF) to "ON" or "OFF."
Slit for the supplied bracket
Insert the bracket and secure with the screw to
mount the unit on the mounting board or flat
surface.
Fuse holder (15A)
When replacing the fuse, be sure to use one
with 15 A.
POWER/OUTPUT connector
Can be connected with the supplied power
connection cable.