Input Connections - Sony XM-S400D Mode D'emploi

Making power connections
Connect the supplied power connection cable to
the POWER/OUTPUT connector on the unit.

*1 Ground (earth) to chassis.
*2 If you have the factory original or some other car
audio unit without a remote output for the amplifier,
connect the remote input (REM) wire of the supplied
power connection cable to the accessory power
supply. With the high level input connection, the car
audio unit can also be activated without need for a
REMOTE connection. However, this function is not
guaranteed for all car audio units.
to a metal point of the car
less than 450 mm (17 3 / in)
4
Fuse (15 A)
+12 V car battery
Car audio

Input Connections

Set the INPUT SELECT switch to "2CH" or "4CH"
according to the input connection.
Also, refer to the manual supplied with your car
audio unit for further details.
 Line input connection
Set the INPUT SELECT switch to "4CH" with the
speaker connection  (page 9).
 Line input connection
Set the INPUT SELECT switch to "2CH" with the
speaker connection  (page 9).
Car audio

Car audio

7
GB