Adjusting The Water Temperature; Factory Reset - Jaga DBH-SET Mode D'emploi

4.2. ADJUSTING THE WATER TEMPERATURE
4.2.1. Adjusting the maximum water tempe-
rature for cooling
By reducing the water temperature setting, the
unit will start later. If the water temperature is
set higher, the unit will start sooner.
1. Put the device in the cooling mode
2. Hold down the [Mode] and [+] simultaneously
until the last 4 LEDs start flashing.
3. Short press the [-] or [+] button to adjust the set temperature.
4. The device returns to the selected mode. (±30sec).
4.3. FACTORY RESET
1. Disable power charge.
2. Press and hold down both the [-] and [+] button on the circuit board
and switch on the power again. The blue LED will light up, followed
by the green LED 2 seconds later and the red LED 4 seconds later.
Release the buttons as soon as all 3 LEDs are flashing.
3. The controller will return to the Factory Default settings, all LEDs will flash for 8 seconds.
JAGA N.V. | DBH SET - TPT | MANUEL | 2021.03.25 | V.03
MODE
12 ̊ C
MODE
MODE
14 ̊ C
MODE MODE
16 ̊ C
MODE
MODE
18 ̊ C
MODE MODE
20 ̊ C
MODE
MODE
22 ̊ C
MODE MODE
24 ̊ C
MODE MODE
26 ̊ C
MODE MODE
4.2.2. Adjusting the minimum water tempe-
rature for heating
By increasing the water temperature setting,
the unit will start later. If the water temperature
is set lower, the unit will start sooner.
In combination with a heat pump, it may be
necessary to reduce the water temperature.
1. Put the device in heating mode
2. Hold down the [Mode] and [+] simultaneously
until the last 4 LEDs start flashing.
15 sec
24 ̊ C
26 ̊ C
28 ̊ C
30 ̊ C
32 ̊ C
34 ̊ C
36 ̊ C
38 ̊ C
/ factory default water temperature
EN
- +
-
33