Home Screen; Setting The Mixed Water Temperature - Watts e-ULTRAMIX 3/4 Manuel D'installation

Date/Hour
30/01/20
mm/dd/yy
dd/mm/yy

Home screen

Fri 30/01/20
55.0
Mixed water
Temperature
Loopback 51.3°C
DHW 65.4°C
Normal
IMPORTANT: if no keys are pressed, after 2 minutes the display reverts to the Home
screen. Press the

Setting the mixed water temperature

F or this setting, it is imperative to simulate normal use by running water through the
draw-off points to ensure the mixed water temperature is set correctly.
Note: draw-off points fitted with antiscald cartridges will prevent water flow if the mixed
water temperature is set above 48 °C.
Languages
1 English
2 Français
3 Dansk
4 Polski
5 Español
6 Italiano
Using the and
The actuator will position itself automatically to obtain the setpoint value on the probe,
Date/Hour
with an admissible deviation of about 1°C.
30/01/20
If the requested setpoint temperature is not reached automatically, the system
mm/dd/yy
records the actuator's last mechanical position (either on manually exiting the
dd/mm/yy
configuration menu, or after 5 minutes).
Mixed T° setting
50.0
°C
Mixed water
EXIT THIS SCREEN TO TERMINATE THE CONFIGURATION PHASE
18
Date/Hour
12:00 30/01/20
12H mm/dd/yy
24H dd/mm/yy
10:52
SD
°C
Mixed water
key once to display the 5 icons at the bottom of the screen.
Quick start guide:
https://wattswater.fr/technical-support/user-manual/mixing-valves/7775/
keys, adjust the setpoint temperature and confirm by pressing
12:00
12H
24H
Mixed water setpoint temperature
(from 30 to 70 °C in 1 °C increments)
Value measured by the mixed water temperature probe.
48.8°C
THEN SHUT OFF THE DRAW-OFF POINTS
12:00
12H
24H
Mixed T° setting
50.0
°C
48.8°C
ENGLISH
EN
.