Zodiac BARACUDA ZIPPY Guide Du Propriétaire page 8

Table des Matières

Les langues disponibles

Cleaning the Zippy Filter

Step 1:

Turn off the pump

Step 2:

Lift the head straight out of the pool.

Step 3:

Disconnect the Zippy head from the hose.

Step 4:

Drain the ZIPPY by turning it with the jet nozzle

towards the pool surface.

Step 5:

Set the ZIPPY on a level surface such as the top

rail of the pool or your pool deck. While holding the

lower body of the machine, twist the upper body

using the tabs provided. Lift the upper body off and

place it on the top rail or the deck.

Step 6:

With the two halves separated, lift the filter screen

out and rinse it. Empty the contents of the bottom

half of the cleaner and rinse it to remove any

remaining debris.

Step 7:

To reassemble, place the cleaned filter screen in

the bottom half of the cleaner. Make sure the

center cone of the screen is pointed down.

NOTE: Placing Zippy on the ground while it is still

connected to the wall fitting may cause unintentional

draining of your pool.

Step 8:

Position the top half over the bottom and twist

until it locks in place. Connect the hoses to the

Zippy head.

Step 9:

Submerge and tilt the head to the side to remove

bubbles and lower it to the pool bottom. Turn the

pump on.

Jet

Nozzle

Table des Matières