Autosen AS005 Notice D'utilisation page 62

Explanation main menu
Flow adjustment to maximum value (high teach)
t�HIGH
= 100 % flow with the operating mode REL�
Flow adjustment to minimum value (low teach)
t�LOW
= 0 % flow with the operating mode REL�
INI Opening of the initialisation menu�
EF Extended functions� Opening of the lower menu level�
Switching output with hysteresis function:
SP1 Set point OUT1�
rP1 Reset point OUT1�
SP2 Set point OUT2�
rP2 Reset point OUT2�
Switching output with window function:
FH1 Upper limit for window OUT1�
FL1 Lower limit for window OUT1�
FH2 Upper limit for window OUT2�
FL2 Lower limit for window OUT2�
Frequency output:
FEP1 End point for flow OUT1�
FrP1 Frequency at the end point (FEP1) OUT1�
FEP2 End point for flow or temperature OUT2�
FrP2 Frequency at the end point (FEP2) OUT2�
FSP2 Start point for temperature OUT2, only for SEL2 = TEMP�
Analogue output:
Analogue start point at OUT2 = flow or temperature value at which the
ASP2
output signal is 4 mA�
Analogue end point at OUT2 = flow or temperature value at which the
AEP2
output signal is 20 mA�
62