Maintenance And Servicing Plan - HOLZMANN MASCHINEN BS 125M Mode D'emploi

Perform a cut
Loosen the clamping lever(4) and swing the saw
arm to the desired angle. Tighten the clamping
lever again to fasten the saw arm in the chosen
position.
Swing the saw arm into the upmost position.
Place the workpiece according to the desired cutting
line and fix it with the vice
Loosen the saw blade guide (7) and move it ap-
prox. 2cm near the workpiece.
Für cutting workpieces of same length, adjust the
workpiece stop (5) accordingly.
Now adjust the speed governor (3) to the desired
feed rate.
Press the green button (2).
Take the feeding handle (1) and press the start
button on it. Wait until the blade reaches its full
speed.
Perform the cut. You should adjust the feed depen-
dent from the material.
Stainless steel, bronze: very slow feed
Steel, brass: slow feed
Aluminium: moderate feed
Wait until band stop and saw
arm in upper position
removing
and/or placing a new workpiece
into the vice.
I N F O R M A T I O N
If you do not use anymore the
band saw the same day, loosen
the saw blade with the knob(9)
a bit.
HOLZMANN Maschinen GmbH
W A R N I N G
before
the cut workpiece
www.holzmann-maschinen.at
MAINTENANCE
Don't clean or do maintenance on
the machine while connected to
the power supply:
Damages to machine and injuries
might occur due to unintended
switching on of the machine!
The machine requires barely no maintenance.
However, if malfunctions and defects occur, let
them be serviced by trained persons only.
Clean your machine regularly after every usage–
it prolongs the machines lifespan and is a prere-
quisite for a safe working environment .
Before first operation as well as later on every
100 operation hours you should lubricate al con-
necting part (if required, remove beforehand with
a brush all swarfs and dust).
Check regularly the condition of the security stick-
ers. Replace them if required..
Check regularly the condition of the guiding rollers
of the saw blade. The good condition and perfect
adjusting of the guiding rollers is essential for a
smooth band saw transport and a clean cut.
Store the machine in a closed, dry location. Do
not expose it to high levels of humidity.

Maintenance and servicing plan

Check for loose or lost
screws
Check for damages of
any machine part
Clean machine
Lubricate all moving
parts (esp. Gear box)
Adjust guiding rollers
A T T E N T I O N
Prior to operation
Prior to operation
After operation
After first 10 op-
erating hours,
later every 3
months
Every month
page 11