Publicité
Les langues disponibles
Les langues disponibles
Fixing the mount on the floor by vacuum
Do not use vacuum fixing on walls or over-head!
Vacuum fixing may only be used if the area to be drilled is level, free of
pinholes
and cracks, otherwise this method cannot be applied.
For the vacuum fixing you need the vacuum set P-54190, vacuum pump and -
hose. They are available on request.
Connect the drill mount and the vacuum pump. Bring the drill mount in the
correct position and switch the pump on.
Check whether all 4 levelling screws in the foot plate are completely turned
back and a vacuum of min. -0.8 bar is achieved. By pressing the valve button
on the handle the drill mount may be disengaged and readjusted.
Screw the quick action clamping screw
(D) into the dowel.
Install the mount.
Fix the washer (E) and finally the
fastening nut (F) on the quick action
clamping screw (D).
Torque the fastening nut with a SW 27
wrench.
Before and after tightening the nut (F) the
adjustable screws have to be adjusted.
Do check whether the mount is installed
safely and firmly.
Screw the plug-in nipple into
the foot plate, to which
previously seal strip has
been applied. Insert the
vacuum handle with the
seal.
Fasten the vacuum handle with a
washer and hexagon hollow head plug
M8x30.
Publicité
