Velleman HAM201 Mode D'emploi page 9

Caution! Each time you replace the batteries, you must reconnect
the alarm to the remote control.
6.3 Installing the Alarm
You can use the alarm free-standing on a horizontal surface, or you
can attach it to a wall. To mount against a wall, proceed as follows:
1. Remove the back cover from the alarm and screw it to the wall
at 1.0–1.5 m above the ground [C].
2. Click the body of the alarm into place on the back cover and fix
it with the screw.
7. Operation
Arming and Disarming the Alarm
 To arm the alarm, press the ARM button [8] on the remote
control. The alarm plays a confirmation tune to indicate that
arming is successful. Note that the alarm is only activated after a
delay of 30 seconds, to allow you to leave the area without
triggering the alarm.
When the alarm detects motion, the siren goes off after a delay of
5 seconds. These 5 seconds allow you to enter the area again and
disarm the alarm before it goes off.
 To disarm the alarm, press the CLR button [9] on the remote
control.
8. Troubleshooting
Problem: I installed the batteries, but the alarm did not beep.
Solution: Make sure that the batteries are installed correctly
according to the polarity markings in the battery compartment.
Problem: The alarm does not arm.
Solution: Make sure that the batteries are installed correctly; that
the cover is fixed in place correctly; and that the indicator LED [7]
on the remote control lights up when pressing the arm or disarm
buttons.
Problem: The red LED is on.
Solution: The batteries are low. Replace the batteries immediately.
V. 03 – 11/12/2014
HAM201
9 ©Velleman nv