Bluetooth Function; Bluetooth Operations; Pairing - Sony MEX-BT2500 Mode D'emploi

Bluetooth function

Bluetooth operations

To use the Bluetooth function, the following
procedure is necessary.

1 Pairing:

When connecting Bluetooth devices for the
first time, mutual registration is required. This
is called "pairing." This registration (pairing)
is required only for the first time, as this unit
and the other devices will recognize each
other automatically from the next time. You
can pair up to 8 devices. (Depending on the
device, you may need to input a passcode for
each connection.)
2 Connection
Sometimes pairing allows to connect
automatically. To use the device after pairing
is made, start the connection.
3 Handsfree talk/Music streaming
You can call a cellular phone and listen to
music when the connection is made.
Pairing
First, register ("pair") a Bluetooth device
(cellular phone, etc.) and this unit with each
other. You can pair up to 8 devices. Once pairing
is established, there is no need for pairing again.
1
Press (OFF).
Be sure the clock or the demonstration
appears.
The Auto off function is set, if the unit is
turned off and the display disappears, press
and hold (OFF) to set the power on.
2
Place the Bluetooth device within 1 m
(3 ft) of this unit.
3
Press and hold (EQ/BLUETOOTH) until
" " flashes (about 7 seconds).
The unit enters pairing standby mode.
4
Set the Bluetooth device to search for
this unit.
A list of detected devices appears in the
display of the connecting device. This unit is
displayed as "XPLOD" on the connecting
device.
5
If Passcode* input is required on the
display of a connecting device, input
"0000."
This unit and the Bluetooth device memorize
each other's information, and when pairing is
made, the unit is ready for connection to the
device.
"
complete.
6
Set the Bluetooth device to connect to
this unit.
"
made.
* Passcode may be called "passkey," "PIN code," "PIN
number" or "Password," etc., depending on the
device.
Note
Pairing standby mode is not released until the
connection is made.
flashing
DR-BT30Q
XPLOD
XXXXXXX
XXXX
" flashes and then stays lit after pairing is
" or " " appears when the connection is
Input passcode.
"0000"
13