Special Functions - LORCH M-Pro Performance Manuel D'utilisation

Delete job
 Press key Tiptronic 50.
 Select menu option „delete job" by turning
operation knob 52.
 Confirm menu option „delete job" by press-
ing operation knob 52.
 Select the job to be deleted by turning op-
eration knob 52.
 Confirm this job by pressing operation
knob 52.
9 Safety question „delete job?" appears.
 Select „YES" to delete this job by turning
operation knob 52.
Abb. 33: delete job
 Confirm „YES" by pressing operation knob
52.
 Press key 46, 50 or 51 to exit menu and
return to standard display.
- 54 -

13.10 Special functions

Gas test
 Turn the unit OFF using main switch 9.
 Press the torch key and keep it pressed.
 Turn the unit ON using main switch 9.
9 The solenoid valve of the unit will go on
and the gas supply can be tested/adjust-
ed. The function is active for 30 seconds
and will be automatically stopped. Re-
pressing the torch key. can interrupt the
gas test.
Fan test
 Turn the unit ON using main switch 9.
9 The fan will start for function purposes.
Operation panel test
 Press the mode key 47 for at least 2 sec-
onds.
9 The complete display panel of the graphic
display will flash.
 Press the key operation mode 47 again.
9 Another display test follows.
 Press the key operation mode 47 again.
9 The operation panel test will be initiated.
 Press and turn the keys as shown in the
graphic display.
‰ If there is no input for 20 seconds, the op-
eration panel test will be cancelled auto-
matically.
Start-up
10.13