Current/Voltage Display; Torch With Remote Control - LORCH M-Pro Performance Manuel D'utilisation

13.3 Current/voltage display

The actual values of welding voltage and
welding current are displayed during and af-
ter welding (hold function).
These values can be displayed individually
or together on the graphic display
Possible display:
‰ Welding voltage and welding current
‰ Welding voltage
‰ Welding current
Abb. 17: Display mode
Change of display mode
 Press menu key 48.
 Select menu option „Display mode" by
pressing operation knob 52.
 Confirm menu option „Display mode" by
pressing operation knob 52.
 Set the desired diisplay mode by turning
operation knob 52.
 Confirm the desired display by pressing
operation knob 52.
9 For about 2 seconds a preview of the dis-
play will be shown if the display mode has
been changed.
- 48 -

13.4 Torch with remote control

Abb. 18: Torch PowerMaster
Torch
65
Displays the actual welding step or wire
feed speed in Tiptronic mode. The cur-
rent job will be displayed
Torch rocker switch
66
Change welding step and wire feed
speed. Between active jobs can
switched over whilst being in Tiptronic
mode.
Torch key „Mode"
67
By pressing (for at least 2 seconds)
changeover between Tiptronic and
regular mode will take place. A quick
press In regular mode change be-
tween wire feed, welding step and
material thickness (at selected charc-
teristics).
Start-up
65 66 67
display
10.13