LORCH M-Pro Performance Manuel D'utilisation page 57

Menu structure
Main menu
Sprache/ Deutsch
language
English
...
Characteristics Manual
SG2/3 0,8mm 82/18
...
Display Mode
Current and Voltage
Welding voltage
Welding current
Tiptronic
Characterist. type
Options
Interval-Welding
Spot Welding
Factory Settings
Firmware Version
Diagnosis
Serial Number
Configuration
Operating Hour Coun-
ter
Op. voltages 60/24V
Transf. Temperature
Main menu
Parameters Spot welding time
Interval time-Welding
Interval time-Wait
Gas pre-flow
Wire creep speed
Wire burnback time
Gas post-flow
10.13
Level 1
EU
AWS
On
On
... reset?
No
Delete All Jobs?
No
Factory
Level 1
settings
1,0 s
1,0 s
0,2 s
0,1 s
2,0 m/min
100 %
0,5 s
Level 2
Select menu language.
All settings can be performed independ-
antly from a characteristic line.
Depending on type of model are various
characteristics set in the manu (material-
gas-wire combination).
Different display settings can be se-
lected.
see chapter „Tiptronic" page 51
Display in accordance to EU (european)
classification.
Display in accordance to AWS (American
Weld¬ing Society) classification.
Off To switch interval welding on/off.
Off To switch spot welding on/off.
Master reset to reset all settings back to
Yes factory settings.
To delete all jobs.
Yes
Displays Firmware Version.
Displays serial no.
Displays machine configuration.
Displays welding time in hours and min-
utes.
Displays voltages in Volt..
Displays temperature in °C..
Range
0,1...10,0 s
0,1...10,0 s
0,1...1,0 s
0,0...10,0 s
1,0...15,0 m/min
0...300 %
0,1...20,0 s
Note
Note
Only available in spot
welding mode.
Only available in interval
mode.
- 57 -